Difference between revisions of "Slicer Profiles"
From MakeICT Wiki
Jump to navigationJump to search (→Slic3r) |
(→Slic3r) |
||
| Line 10: | Line 10: | ||
#Check back here for updates | #Check back here for updates | ||
=== Current === | === Current === | ||
| − | *Download file: [https://drive.google.com/open?id= | + | *Download file: [https://drive.google.com/open?id=0B9tsLcc_rWFAakh2MnZaNDMxVU0 slic3r_config_bundle_09-10-17ini] |
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
Revision as of 20:34, 10 September 2017
Below are the default slicer profiles for the 3d printers at MakeICT.
Slic3r
To use these files:
- Download Slic3r
- Run Slic3r
- Download the current config bundle on this page
- File -> Load Config Bundle
- Select downloaded config file
- Check back here for updates
Current
- Download file: slic3r_config_bundle_09-10-17ini
