Difference between revisions of "Slicer Profiles"
From MakeICT Wiki
Jump to navigationJump to search| Line 3: | Line 3: | ||
== Slic3r == | == Slic3r == | ||
To use these files: | To use these files: | ||
| − | #[ | + | #[https://github.com/prusa3d/Slic3r/releases Download Slic3r Prusa Edition] |
#Run Slic3r | #Run Slic3r | ||
#Download the current config bundle on this page | #Download the current config bundle on this page | ||
Revision as of 15:41, 20 December 2018
Below are the default slicer profiles for the 3d printers at MakeICT.
Slic3r
To use these files:
- Download Slic3r Prusa Edition
- Run Slic3r
- Download the current config bundle on this page
- File -> Load Config Bundle
- Select downloaded config file
- Check back here for updates
Current
- Download file: 2018-12-20_MakeICT_Slic3r_config_bundle.ini
