Difference between revisions of "Slicer Profiles"
From MakeICT Wiki
Jump to navigationJump to search| Line 11: | Line 11: | ||
=== Current === | === Current === | ||
*Download file: [https://drive.google.com/open?id=19IaIPBA8IXpZhsH5y__BsfXCHexf_7VI 2018-12-20_MakeICT_Slic3r_config_bundle.ini] | *Download file: [https://drive.google.com/open?id=19IaIPBA8IXpZhsH5y__BsfXCHexf_7VI 2018-12-20_MakeICT_Slic3r_config_bundle.ini] | ||
| + | === Vendor Profiles === | ||
| + | You can also install the vendor profiles so that your settings will be updated automatically. Instructions pending. | ||
Revision as of 15:58, 20 December 2018
Below are the default slicer profiles for the 3d printers at MakeICT.
Slic3r
To use these files:
- Download Slic3r Prusa Edition
- Run Slic3r
- Download the current config bundle on this page
- File -> Load Config Bundle
- Select downloaded config file
- Check back here for updates
Current
- Download file: 2018-12-20_MakeICT_Slic3r_config_bundle.ini
Vendor Profiles
You can also install the vendor profiles so that your settings will be updated automatically. Instructions pending.
