Difference between revisions of "Slicer Profiles"
From MakeICT Wiki
Jump to navigationJump to search| Line 3: | Line 3: | ||
== Slic3r == | == Slic3r == | ||
To use these files: | To use these files: | ||
| − | #[https:// | + | #[https://www.prusa3d.com/drivers/ Download PrusaSlicer] |
| − | #Run | + | #*From the section labeled "Drivers & Apps" |
| + | #Run the installer | ||
| + | #*Select only the first option, unless you want to install other components | ||
| + | === Vendor Profiles === | ||
| + | |||
| + | |||
#Download the current config bundle on this page | #Download the current config bundle on this page | ||
#File -> Load Config Bundle | #File -> Load Config Bundle | ||
| Line 11: | Line 16: | ||
=== Current === | === Current === | ||
*Download file: [https://drive.google.com/open?id=19IaIPBA8IXpZhsH5y__BsfXCHexf_7VI 2018-12-20_MakeICT_Slic3r_config_bundle.ini] | *Download file: [https://drive.google.com/open?id=19IaIPBA8IXpZhsH5y__BsfXCHexf_7VI 2018-12-20_MakeICT_Slic3r_config_bundle.ini] | ||
| − | |||
| − | |||
Revision as of 03:38, 21 August 2019
Below are the default slicer profiles for the 3d printers at MakeICT.
Slic3r
To use these files:
- Download PrusaSlicer
- From the section labeled "Drivers & Apps"
- Run the installer
- Select only the first option, unless you want to install other components
Vendor Profiles
- Download the current config bundle on this page
- File -> Load Config Bundle
- Select downloaded config file
- Check back here for updates
Current
- Download file: 2018-12-20_MakeICT_Slic3r_config_bundle.ini
