|
|
| Line 1: |
Line 1: |
| − | It will be necessary to be trained in the [[LASER Cutter Basics Class]] to get a full understanding of the design and use of the LASER cutter.
| + | #REDIRECT [[Laser Cutter]] |
| − | * These classes are presented to teach several people at a time, however because of the hands on portion of the class, the class will not contain more than 5 students at a time.
| |
| − | ** How does the LASER cutter work
| |
| − | ** Proper use and control of the LASER cutter
| |
| − | ** Discussion of the software that creates the files and how the files are accessed on the LASER cutter
| |
| − | ** What is expected of each user of the LASER cutter
| |
| − | ** How to troubleshoot problems and report problems that cannot be resolved
| |
| − | * LASER cutter instructors teach the LASER Cutters Basics class and certify that they have covered the material and validate all of the above using the LASER cutter certification form
| |
| − | ** '''LASER Cutter Certification form'''
| |
| − | ** The form will be signed and dated by the member who just got certified
| |
| − | ** The form will be signed and dated by the LASER cutter instructor
| |
| − | ** The form will be retained by MakeICT
| |
| − | ** The new certified member will be entered on the FabLab LASER Cutter certified user section on the Wiki
| |
| − | * It is the responsibility of all certified LASER cutter users to review any published information at the LASER cutter area
| |
| − | * It is the responsibility of all certified LASER cutter users to update their certification if there are any changes that require any new forms to be signed
| |
| − | * Failure to comply with the LASER cutter certification rules could have their certification revoked
| |
