LASER Cutter Materials
From MakeICT Wiki
Revision as of 05:20, 18 October 2015 by Mike Doolittle (talk | contribs)
Approved Organic Materials
If your material is not on the list, check with Brian or Mike
| Name | Engrave | Cut | Max thickness | Notes | WARNING |
|---|---|---|---|---|---|
| Acrylic (aka Lucite, Plexiglas, PMMA) | x | x | 1/2" | Cuts well, leaves a smooth polished edge. Higher powers can leave smoke/scorch marks along edges | |
| Cardboard, cartons | x | x | thicker | Cuts well, can catch fire | FIRE hazard! |
| Ceramic | x | ||||
| Cloth (cotton, felt, hemp) | x | x | Cuts easily | NO plastic coated or impregnated cloth! | |
| Corian | x | x | |||
| Cork | x | x | 1/4" | Cuts nicely, the quality of the cut depends on the thickness and quality of the cork. Engineered cork has a lot of glue in it, may not cut nicely. | |
| Delrin | x | x | |||
| Fabric (polyester) | x | x | |||
| Fiberglass | x | x | |||
| Glass | x | ||||
| Leather, suede | x | x | |||
| Marble | x | ||||
| Matte Board | x | x | |||
| Melamine | x | x | |||
| Mylar | x | x | |||
| Paper, card stock | x | x | thin | ||
| Pressboard | x | x | |||
| Rubber | x | x | |||
| Wood | x | x | |||
| Wood Veneer | x | x |
Approved Metal Materials
| Name | Engrave | Cut | Notes |
|---|---|---|---|
| Painted Metals | x | ||
| Tile | x | ||
| Bare Metals | x | ||
| Anodized Aluminum | x | ||
| Brass | x | ||
| Coated Metals | x | ||
| Stainless Steel | x | ||
| Titanium | x |
- CO2 lasers will engrave metals when coated with an added metal marking solution.
