Slicer Profiles
From MakeICT Wiki
Revision as of 15:58, 20 December 2018 by Christian Kindel (talk | contribs)
Below are the default slicer profiles for the 3d printers at MakeICT.
Slic3r
To use these files:
- Download Slic3r Prusa Edition
- Run Slic3r
- Download the current config bundle on this page
- File -> Load Config Bundle
- Select downloaded config file
- Check back here for updates
Current
- Download file: 2018-12-20_MakeICT_Slic3r_config_bundle.ini
Vendor Profiles
You can also install the vendor profiles so that your settings will be updated automatically. Instructions pending.
