Slicer Profiles
From MakeICT Wiki
Revision as of 03:38, 21 August 2019 by Christian Kindel (talk | contribs)
Below are the default slicer profiles for the 3d printers at MakeICT.
Slic3r
To use these files:
- Download PrusaSlicer
- From the section labeled "Drivers & Apps"
- Run the installer
- Select only the first option, unless you want to install other components
Vendor Profiles
- Download the current config bundle on this page
- File -> Load Config Bundle
- Select downloaded config file
- Check back here for updates
Current
- Download file: 2018-12-20_MakeICT_Slic3r_config_bundle.ini
