Difference between revisions of "Fusion 360: Sketching for Makers"
From MakeICT Wiki
Jump to navigationJump to searchBrad Cozine (talk | contribs) m |
|||
| (6 intermediate revisions by one other user not shown) | |||
| Line 1: | Line 1: | ||
| − | |||
This class is the first in a series of classes on the AutoDesk Fusion software. There will be follow on classes in how to create 3D models and how to do some basic NC milling operations. | This class is the first in a series of classes on the AutoDesk Fusion software. There will be follow on classes in how to create 3D models and how to do some basic NC milling operations. | ||
| Line 13: | Line 12: | ||
*Final Exercise; Bring in a real life project to get started on | *Final Exercise; Bring in a real life project to get started on | ||
| − | Book: [[Fusion360Sketch.pdf]] | + | Book: [[Media:Fusion360Sketch.pdf|Fusion360Sketch.pdf]] |
| + | [[Category:Classes]] | ||
Latest revision as of 14:38, 8 May 2022
This class is the first in a series of classes on the AutoDesk Fusion software. There will be follow on classes in how to create 3D models and how to do some basic NC milling operations.
AGENDA
- Introduction and Interface lecture
- Follow along exercise
- Basic Sketching lecture
- Basic Sketching exercises that you do on your own in the book
- Exercise 1 (no written instructions)
- Advanced Sketching lecture
- Advanced Sketching exercises you do on your own in the book
- Exercise 2 (no written instructions)
- Final Exercise; Bring in a real life project to get started on
Book: Fusion360Sketch.pdf
