Difference between revisions of "3D Printing Lessons"
From MakeICT Wiki
Jump to navigationJump to search| Line 3: | Line 3: | ||
As of the moment, the lessons are not done, if you manage to get here, think of them as a VERY rough draft, really on some a stream of consciousness. | As of the moment, the lessons are not done, if you manage to get here, think of them as a VERY rough draft, really on some a stream of consciousness. | ||
| − | [[3D Printing Lesson 1: Introduction to 3D Printing]] | + | ===[[3D Printing Lesson 1: Introduction to 3D Printing]]=== |
| − | [[3D Printing Lesson 2: What we can do at MakeICT]] | + | A very general introduction to 3D printing or additive manufacturing. |
| + | ===[[3D Printing Lesson 2: What we can do at MakeICT]]=== | ||
| + | An introduction to what MakeICT printers can do. | ||
Revision as of 23:34, 3 May 2016
This will be a series of 3D Printing Lessons that are produced ideally weekly, and form a series of lessons to get people up to speed on 3D printing. It does presume some 3D modeling knowledge, for some things, which is something we hope to have lessons on in the future.
As of the moment, the lessons are not done, if you manage to get here, think of them as a VERY rough draft, really on some a stream of consciousness.
3D Printing Lesson 1: Introduction to 3D Printing
A very general introduction to 3D printing or additive manufacturing.
3D Printing Lesson 2: What we can do at MakeICT
An introduction to what MakeICT printers can do.
