Difference between revisions of "FabLab Area"

From MakeICT Wiki
Jump to navigationJump to search
Line 15: Line 15:
 
* Intro to 3D Printing
 
* Intro to 3D Printing
 
* Advanced 3D Printing and Modeling
 
* Advanced 3D Printing and Modeling
* Laser Cutter Basics - contact [[User:Mike Doolittle|Mike Doolittle]]  
+
* [[Laser Cutter Basics Class]]
  
 
== Equipment List ==
 
== Equipment List ==

Revision as of 16:05, 20 September 2015

Attention! This page or section is out of date. Help us out by modifying this page.
Details: missing details and access policies


General Information

MakeICT's FabLab is an open 200 sq ft area dedicated to fabrication.

Bryan Barr is the Benevolent Dictator over the FabLab.

Machine Access Policy

  • To use the Laser Cutter you must take the Laser Cutter Basics class
  • Certification is under construction
  • List of Laser Cutter approved users is listed below

Classses

Equipment List

Picture What Manufacturer Model Power Status Expert How To
3D-Printer.jpg 3D Printer RepRap 110 Working James Lancaster Information
Ultimaker II.jpeg 3D Printer Ultimaker Ultimaker II 110 Working Tom McGuire instructions
Foam-Cutter.jpg Foam Cutter Tom McGuire 110 Working Tom McGuire Basic Use Guidelines
Laser cutter.jpg Laser Cutter Rabbit Laser QX1290 230 Working Mike Doolittle Laser Cutter Guidelines

Laser Cutter Approved Users

Name Notes
Bryan Barr FabLab BD
Mike Doolittle Laser Cutter instructor
Jerry Carpenter
David Springs
William Davisson
Brad Cooley
Ivan Quiroz
Jonny Fosnight
John Alexanders
Stephen Reckers
Mike Hutton