Outreach Committee

The goal of the outreach gaggle is to _______________________. We do this by _______________. This page is a resource for members of the gaggle to share ideas and activities.

The Outreach Gaggle is led by Barbara Davis

Upcoming events

• 2016-January-27 - Southeast High School STEM night
  • #Intro to soldering
• 2016-January-29 Tinker Tech training for Exploration Place
• 2016-February-20 - SWE Engineering Expo
  • #Markerbots
  • #3D Printer demo
  • #Binary card reader

Activities

Title	Structured	Make'n'Take	Duration(Minutes)	Grade Level
3D Printer Demo	No	No	-	Any
Brush Bots	No	Yes	5	K-2
Intro to Soldering	Yes	Yes	120	Any
Marker Bots	No	Yes	5	K-2

3D Printer Demo

Someone please fill this in!

Brush bots

Teaches participants about basic electricity and closed circuits.

Supplies

• Toothbrushes - 1 per participant
• Pager motors - 1 per participant
• Watch batter (CR2025?) - 1 per participant
• Double-sided tape - 1" per participant
• Optional
  • Acrylic paint
  • Paper plates
  • Paper

Preparation

1. Cut brush heads of toothbrushes
2. Squirt paint in distinct blobs on paper plates

Procedure

1. Cut tape
2. Stick the stuff to the other stuff

Intro to soldering

Teach people how to use soldering irons. This is a hands-on activity that requires some 1-on-1 supervision and has make-it-take-it output.

Supplies

• Soldering irons and sponges - 1 per X participants
• Solder wick - 1 per soldering iron
• Solder spool - 1 per soldering iron
• Helping hands or clamps - 1 per soldering iron
• Work mat (piece of cardboard works fine) - 1 per soldering iron
• Something to solder - 1 per X participant
• Extension cords / surge protectors

Preparation

1. Lay out soldering irons and mats
2. Plug in and turn on irons so they are ready to go

Procedure

1. Demonstrate how to hold the soldering iron
2. Tin the tip (melt a small bit of solder onto the iron tip)
3. Press the component to the pad
4. Use the iron tip to heat the component and pad
5. While holding the iron to the component/pad, melt solder onto the component/tab. Do not melt the solder on the iron
6. While still holding the iron to the component/pad, pull the solder away
7. Allow the solder to flow around the pad and component
8. Pull the iron away
9. Clean the tip
10. Return the iron to its holder

Notes

Soldering irons are hot.

Markerbots

Someone please fill this in!