Difference between revisions of "Electronic Door Entry"
From MakeICT Wiki
Jump to navigationJump to search (Created page with "== Hardware Specs == * * * == Software Roadmap == * Version 1.0") |
Rye Kennedy (talk | contribs) (Updated hardware list) |
||
| Line 1: | Line 1: | ||
== Hardware Specs == | == Hardware Specs == | ||
| − | * | + | *Electric door strike (12V, 250 mA), will be wired fail secure, i.e. applying electric current to the strike will cause it to unlock |
| − | * | + | *RFID/NFC card reader (MiFare cards), purchased this [one]http://www.ebay.com/itm/PN532-NFC-RFID-Controller-Reader-Writer-Kit-For-Arduino-UNO-Mega-2560-R3-A124-/271186702139?pt=LH_DefaultDomain_0&hash=item3f23fcaf3b |
| − | * | + | *card reader can communicate via I2C/Uart/SPI |
| + | *two status LED's | ||
| + | *interposing circuit for door strike/RPI | ||
| + | |||
| + | Outdoor enclosure to hold card reader: | ||
| + | [Tom fill in here] | ||
| + | *will hold card reader | ||
| + | *"Power" LED, red LED that will be on continuously if there is power | ||
| + | *"Status" LED, green LED that will blink a sequence with succesful card read, also blink a different sequence if failed authentication | ||
| + | |||
| + | RaspberryPi: | ||
| + | *GPIO list: | ||
| + | **status LED's | ||
| + | **door latch interposing circuit | ||
| + | **door latch buzzer (let the user know the solenoid has been energized) | ||
| + | **door reed switch (door status) | ||
| + | ** | ||
== Software Roadmap == | == Software Roadmap == | ||
* Version 1.0 | * Version 1.0 | ||
Revision as of 19:28, 10 February 2014
Hardware Specs
- Electric door strike (12V, 250 mA), will be wired fail secure, i.e. applying electric current to the strike will cause it to unlock
- RFID/NFC card reader (MiFare cards), purchased this [one]http://www.ebay.com/itm/PN532-NFC-RFID-Controller-Reader-Writer-Kit-For-Arduino-UNO-Mega-2560-R3-A124-/271186702139?pt=LH_DefaultDomain_0&hash=item3f23fcaf3b
- card reader can communicate via I2C/Uart/SPI
- two status LED's
- interposing circuit for door strike/RPI
Outdoor enclosure to hold card reader: [Tom fill in here]
- will hold card reader
- "Power" LED, red LED that will be on continuously if there is power
- "Status" LED, green LED that will blink a sequence with succesful card read, also blink a different sequence if failed authentication
RaspberryPi:
- GPIO list:
- status LED's
- door latch interposing circuit
- door latch buzzer (let the user know the solenoid has been energized)
- door reed switch (door status)
Software Roadmap
- Version 1.0
