Difference between revisions of "Ultimaker 2"
From MakeICT Wiki
Jump to navigationJump to searchm |
|||
| Line 25: | Line 25: | ||
STL files can be sliced using [https://ultimaker.com/en/products/cura-software Cura]. The resulting gcode file is saved on an SD card and prints are run through the built in interface without needing to be connected to a computer. | STL files can be sliced using [https://ultimaker.com/en/products/cura-software Cura]. The resulting gcode file is saved on an SD card and prints are run through the built in interface without needing to be connected to a computer. | ||
| − | | | + | |acquisition = This printer was purchased using grant money from the Wichita Community Foundation and the Knight Foundation. |
}} | }} | ||
Revision as of 17:19, 23 June 2016
| Ultimaker 2 | |
|---|---|
 Ultimaker 2 3D printer | |
| Technical Specifications | |
| Build Volume | 230 x 225 x 205 mm |
| Filament Types | PLA, ABS, CPE |
| Filament Sizes | 2.85 mm, 1.75 mm |
| X/Y Resolution | 0.125mm |
| Z Resolution | 0.02mm |
| Nozzle Diameter | 0.4mm |
| Max Nozzle Temperature | 250° C |
| Heated Bed | yes |
| Max Bed Temperature | 100° C |
| Additional Information | |
| User Manual | Ultimaker 2 - User Manual v1.13.pdf |
| Website | Ultimaker 2 Support |
Contents
Features
Due to its ease of use and ability to produce high Quality prints, the Ultimaker 2 is the most popular 3D printer at MakeICT. A couple of modifications have been made to allow it to use 1.75mm filament with minimal re-configuration.
Access Policy
See 3D Printing for access policy.
Use
Attention! This page or section is out of date. Help us out by modifying this page.
Details: Add detailed instructions
Details: Add detailed instructions
STL files can be sliced using Cura. The resulting gcode file is saved on an SD card and prints are run through the built in interface without needing to be connected to a computer.
Acquisition
This printer was purchased using grant money from the Wichita Community Foundation and the Knight Foundation.
