Electronics and Rapid Prototyping

From MakeICT Wiki
Jump to navigationJump to search
Attention! This page or section is out of date. Help us out by modifying this page.
Details: missing details and access policies


General Information

MakeICT's Electronics and Rapid Prototyping lab is an enclosed 200 sq ft area dedicated to creating and debugging electronics, as well as some rapid prototyping capabilities.

James Seymour is the Benevolent Dictator over the electronics and rapid prototyping lab.


Classes

Machine Access Policy

Clean up! Users are responsible for clean up after themselves; failure to which may result in loss of E&RP Privileges.

Scopes and Analyzers

Use of the Scopes and Analyzers requires certification from a reasonably knowledgeable member (when in doubt ask).

  • List of known Scope and analyzer users is listed below

Circuit Design and Fabrication

Use of the C requires attendance in a foam cutter certification workshop or certification from an approved peer-certifier.

  • Any member who has been certified to use the foam cutter may peer-certify other members
  • Certification instruction must at least include
    • Fundamental knowledge of foam cutter's working principles
    • Proper use and control of foam cutter
    • Software workflow
  • Certification must be documented (link to instructions or form) prior to use
  • List of Foam Cutter Certified users is listed below

LASER Cutter

Use of the LASER cutter requires attendance in LASER Cutter Basics Class

  • Certification must be documented (link to instructions or form) prior to use
  • List of LASER Cutter Certified users is listed below

FabLab Area Safety

  1. Do not use any machine you are not trained on and comfortable using. If at any time you are unsure of what you are doing, stop immediately and ask for help.
  2. Do not use any machine that is not in good working order. Stop, unplug and leave a note on the machine and notify the FabLab BD OR Mike Doolittle.
  3. NEVER ASSUME A TOOL IS PROPERLY ADJUSTED. Always check the tool prior to use.
  4. NEVER MODIFY OR HACK THE 3D PRINTER, FOAM CUTTER OR LASER CUTTER.


Equipment List

Picture What Manufacturer Model Power Status Expert
RD500 II photo.jpg RD-500S II Area Array Rework System Den-on Instruments RD-500S II 110 Not yet James Seymour
TEK1240.jpg Logic Analyzer Tektronix 1240 110 Working James Seymour
TEK492P.jpg Programable Spectrum Analyzer Tektronix 492P 110 Working James Seymour
TEK465B.jpg Oscilloscope Tektronix 465B 110 Working James Seymour
QS-5100.jpg Lead Free Reflow Oven Qinsi Technology QS-5100 110 Working James Seymour
Arksen992D.jpg Soldering Station with Heat Gun Arksen 992D 110 Working James Seymour

Rapid Prototyping

Picture What Manufacturer Model Power Status Expert
Fireball v90.jpg 3-axis CNC Machine Probotix Fireball V90 110 Working ??